Figure 26. Connect Jam Sensor Assembly - TransAct Epic 430 Maintenance Manual

Step 4. Connect Jam Sensor Assembly
Jam sensor bracket
Jam sensor

Figure 26. Connect Jam Sensor Assembly

• Attach Jam Sensor to the corresponding slot on the Jam Sensor Bracket,
mounting the sensor into the center opening, then pressing the wiring into
place inside the tab on the right side of the assembly.
Snap the Jam Sensor Bracket on top of the Knife Assembly, pressing
•
down into place as shown in the figure.
Press down into place
43-06955 - Rev Q
Assembly and Disassembly
Page 61