Figure 27. Connect Paper Path Assembly - TransAct Epic 430 Maintenance Manual

Assembly and Disassembly
Step 5. Connect Paper Path Assembly
Top of Form sensor
Bottom paper guide
Paper out sensor

Figure 27. Connect Paper Path Assembly

• With the Paper Out and Top of Form sensors previously mounted to the
Bottom Paper Guide, attach the Bottom Paper Guide to the Right Side
Frame Assembly using a self-tapping plastic screw near the top edge of
the Right Side Frame Assembly.
Connect the Paper Out wiring harness to connector CN9 (white) and the
•
Top of Form wiring harness to connector CN13 (yellow) on the Right Side
Assembly printed circuit board.
Connect the Tie-Wrap Bundles of wiring harnesses for remaining sensor
•
and motor connections to the appropriate color-coded locations on the
sensors, motors at one end, and the Right Side Frame Assembly printed
circuit board at the other end.
• Connect three Umbilical Cables to the connections shown on the Right
Side Assembly printed circuit board for the Print Head (CN3), Sensors
(CN2) and Motors (CN1).
Page 62
Umbilical cables (3)
43-06955 - Rev Q
Tie-wrap bundles