Motorola MT 2000 User Manual page 232

CHANGE/VIEW
PTT ID Sidetone
Use the UP/DOWN arrow keys to enable or disable the PTT ID Sidetones. During the transmission of data
packets, the microphone and all voice transmission is automatically disabled. PTT ID Sidetones are used to
indicate when the data transmission is complete and you may begin talking.
If PTT ID Sidetones are enabled, a continuous alert tone will sound as soon as you press PTT and will continue
until the data packet(s) has been sent. You must wait until the tone stops before you begin talking
Trailing PTT ID
Use the UP/DOWN arrow keys to enable or disable the MDC UNIT IDENTIFICATION data packet transmission
at the END of each transmission (EOT).
If the trailing PTT ID feature is enabled, each time you release the microphone PTT, the radio automatically will
send the radio's unit identification code to the dispatcher.
The PTT ID Sidetone will NOT sound for trailing PTT IDs.
Radio Check
Enabling this option allows the dispatcher to check the state of the radio (turned on or off), as long as the radio is
within the range of the system. (clear mode)
Radio Inhibit
This field indicates whether or not the Radio Inhibit feature is enabled.
Enabling this field allows the radio to respond to a remote inhibit command. Upon receipt of this command the
radio transmits an acknowledgement to the dispatch equipment; it then goes into a dormant state in which the
receiver audio is muted, the transmit audio path is blocked, all operator controls are rendered inoperative,
channel scan is stopped on the Radio Operating mode which received the command, and all LEDs are turned off.
The radio can be un-inhibited via sending a radio enable command or by reading and writing the codeplug with
the RSS.
Status
This field indicates whether or not the Status feature is enabled. The Status feature, when enabled, allows the
user to select and transmit a specific status from a list pre-programmed into the radio. A complete activation of
the Status feature therefore includes first enabling the feature and then programming the desired status list to be
made available to the user. Status list programming is performed by means of the Status Alias screen (MAIN
MENU-F4/F6/F9). The factory default is Disabled.
Status Request
This field indicates whether or not the Status Request feature is enabled. If Status Request is enabled, the radio
responds to a remote status interrogation with the last attempted status. Disabling the feature prohibits the radio
from responding to a remote status interrogation. The factory default is Disabled.
Message
This field indicates whether or not the Message feature is enabled. Message, when enabled, allows the user to
select and transmit a specific message, from a list pre-programmed into the radio. A complete activation of the
Message feature therefore includes first enabling the feature and then programming the desired list of messages
to be made available to the user. Message list programming is performed by means of the Message Alias screen
(MAIN MENU-F4/F6/F8). The factory default is Disabled.
Emergency
This field indicates whether or not the Emergency feature is Enabled.
6-106
MTSX RSS
68P81074C50