Motorola MT 2000 User Manual page 159

CHANGE/VIEW
FIELD DEFINITIONS:
Nuisance Mode Delete
This option allows you to temporarily delete non-priority channels from the scan list that are constantly busy
which may cause the radio to be constantly locked onto a channel. A channel deleted using this option will remain
deleted until scan is stopped. When scan is started again, all channels which were previously deleted will be
replaced. Factory default is Enabled.
Priority Scan Alert
If this option is enabled, the radio will audibly alert the user when it unmutes on a priority channel while scanning.
One beep is generated for the priority talkgroup in a trunked scan list, or for the first priority channel in a
conventional scan list. Two beeps are generated for the second priority channel in a conventional scan list.
Factory default is Disabled.
Rx Hold Time (sec)
This is the amount of time the radio remains on a channel after a message has been received before scanning
resumes. Valid entries are 0 to 255 seconds in 1 second increments. Factory default is 3 seconds.
HUB Suspends Scan
Use the UP/DOWN arrow keys to Enable/Disable the HUB Suspends Scan feature. HUB Suspends Scan will
determine if the scan operation will be suspended while the microphone is removed from the hang up box. If HUB
Suspends Scan is enabled, scan operation will be suspended while the microphone is removed from the hang up
box. This will allow the user to complete a conversation while scan is suspended. For portables this option is
applicable when a Vehicular Adapter is used.
The factory default is Disabled.
Carrier Detect Required
When this option is enabled, the priority channels will stop on carrier squelch detect but only unmute on the
standard signaling conditions programmed for that channel. Factory default is Disabled.
Priority Chan Marking
When this option is enabled and the radio is in Priority Scan Mode, the radio checks the channel for activity and
proper PL. If the channel has carrier but the wrong PL or no PL, the channel is marked so the radio will not
recheck for the proper PL. The radio will not unmute on this channel until the carrier is dropped.
This is done to prevent the PL decode time from being added to the audio hole time when the radio is unmuted
on a non-priority channel and is sampling the priority channel. Care should be exercised in using this feature - it
is possible for messages to be missed, especially if long repeater hangtimes are used. Factory default is
Disabled.
Monitor Hold Time (sec)
Scan monitor hold time is the time the radio remains on a conventional channel during scan after the monitor
button has been released. Valid entries are 0 to 255 seconds in 1 second increments. Factory default is 6
seconds.
Voting Scan
Conventional Voting Scan is used to select the best repeater to use in a multi-frequency simulcast conventional
system. Enabling this field will cause all conventional personalities using a conventional scan list with
Auto Scan enabled (Main->F4->F6->F3->F9) to perform conventional voting scan. Before using Conventional
Voting Scan, you must first create a conventional scan list which contains all repeaters in the Conventional
Voting Scan wide area network. Each conventional personality in this list must have Auto Scan enabled. The
factory default is Disabled
Having more than 7 list members in a conventional scan list used for
Conventional Voting Scan may degrade performance, resulting in missed
transmissions.
6-32
Warning
MTSX RSS
68P81074C50