Table of Contents
Advertisement
5.9
Installing/Removing the Power Elevating Legrests
WARNING
To prevent personal injury, always verify proper positioning of legs and feet prior to use. Individual user weight may impact
the rate of travel for each legrest assembly. If simultaneous operation is desired, select a speed which allows for the most
uniform travel.
DO NOT insert fingers between legrest components, otherwise personal injury may occur.
CAUTION
Never allow items to become trapped between the legrest assemblies, otherwise damage to the power legrests may occur.
Ensure that all parts of both power legrests are clear of any obstructions before raising and lowering, otherwise damage to
the power legrests may occur.
Refer to FIGURE 10 on page 44.
Installing the Power Elevating Legrests
1.
Turn power legrest to side (open footplate is perpendicular to wheelchair) (Detail "A" of FIGURE 10).
2.
Insert the mounting pin of power legrest into the mounting hole of the seat frame (Detail "A" of FIGURE 10).
Make sure the legrest sits flush on the seat frame.
3.
Rotate the power legs toward the INSIDE of the wheelchair until it locks in place.
The footplate will be on the INSIDE of the
wheelchair when locked in place.
4.
Repeat STEPS 1-3 for the opposite legrest.
5.
Connect power legrest connector to jumper cable (Detail "B" of FIGURE 10).
Part No 1143192
43
5 USAGE
Invacare® Adjustable ASBA Seats
Advertisement
Table of Contents
