Table of Contents
Advertisement
5.3
Operating Powered Seating Systems
GENERAL WARNINGS
Refer to A Note About Drive Lock-Out on page 30 before performing this procedure.
Pinch points may occur when returning the seat from any tilted position to the full upright position or when lowering the
elevating seat. Make sure the hands and body of both the occupant and attendants/bystanders are clear of all pinch points
before returning the seat to the full upright position or lowering the elevating seat.
NEVER operate the wheelchair while the back is in any tilted/back angle position over 20° relative to the vertical position. If
the drive lock-out does not stop the wheelchair from operating in a tilt/back angle position over 20° relative to the vertical
position, DO NOT operate the wheelchair. DO NOT attempt to adjust the drive lock-out. Have the wheelchair serviced
by a qualified technician.
Use caution when driving in a tilted position.
DO NOT operate the seating system while on an incline.
DO NOT operate seating system while the wheelchair is moving.
DO NOT operate the tilt function near or under a fixed object such as a table or desk.
ACTUATOR CONTROL WARNING
Use only the actuator controls listed in the following chart to activate the tilt/recline/elevate functions. DO NOT USE any
other actuator controls. Such devices may result in excess heating and cause damage to the actuator and associated wiring
and could cause a fire, death, physical injury or property damage. If such devices are used, Invacare shall not be liable and the
limited warranty is void.
SYSTEM TYPE
Single Actuator (Tilt Only)
Part No 1143192
JOYSTICK
MK6i SPJ+ w/PSS
MK6i SPJ+ w/ACC
CMPJ+
31
POWERED SEATING CONTROL
4 POLE MOTOR
SWITCH OPTION
Powered Seating Switch
5 USAGE
THROUGH THE JOYSTICK (TTJ)
No
Yes
Yes with SANODE
Invacare® Adjustable ASBA Seats
Advertisement
Table of Contents
