7.5
Adjusting/Replacing Telescoping Front Rigging Support
WARNING
If the telescoping tubes need to be extended greater than two inches, then the seat must be repositioned rearward to
ensure stability - otherwise personal injury and/or damage to the wheelchair and surrounding property may result.
1.
Remove the two cap screws, spacers and threaded blocks securing the telescoping front tube to the side rail.
2.
Perform one of the following:
•
Slide existing telescoping front rigging support to one of six depth positions.
•
Remove existing telescoping front rigging.
3.
Secure the telescoping front tube to the side rail at the desired depth with the existing two cap screws, spacers and threaded blocks.
4.
Repeat STEPS 1 to 3 on the opposite side, if desired.
Part No 1143192
Side Rail
Cap Screws
Spacers
FIGURE 2 Adjusting/Replacing Telescoping Front Rigging Support
Side Rail
Spacers
Threaded
Blocks
67
7 SETUP/MAINTENANCE
Cap Screws
Telescoping
Front Tube
Invacare® Adjustable ASBA Seats