Table of Contents
Advertisement
5 USAGE
One of the following will occur when the drive lock-out feature has been activated:
•
CMPJ+ Joysticks Only -
•
SPJ+ Joysticks Only - Left to right chase alternating with a steady display.
Drive lock-out is a feature designed to prevent the wheelchair from being driven after the seating system has been tilted
beyond 20°* relative to the vertical position. This may affect the wheelchair user's line of sight while driving. Make sure the
wheelchair user can see properly to ensure safe driving.
*20° back angle can be any combination of tilt, back angle and/or surface angle.
Tilt is a term used to define the angle between the seat rails and the ground/floor.
To tilt the seat parallel back to the upright position, reverse the following procedure.
1.
Place the wheelchair on a level surface.
2.
Inform the occupant of the wheelchair that the wheelchair is about
to be tilted and remind them to lean back.
3.
Make sure the occupant's hands and body are clear of all pinch
points.
4.
Stand behind the wheelchair and grasp both release levers on the
stroller handle.
5.
Pull up on the two tilt release levers to disengage the manual tilt
system.
6.
Slowly, push down on the stroller handle while holding on the
release levers in a continuous motion.
7.
When the seat reaches the desired angle, slowly let go of the two
release levers to engage the manual tilt system.
Invacare® Adjustable ASBA Seats
TILT WARNING or
SPM Inhibited displays on the joystick or display unit.
FIGURE 15
50
Seat Lock (Left)
Wheelchair
Release Lever
Base
Operating the Manual Tilt Option (TDX Spree Only)
Seat Assembly in
Tilted Position
Tilt (Right) Release
Lever
Stroller
Handle
Part No 1143192
Advertisement
Table of Contents
