Installing/Removing Seat Positioning Strap; Installing/Removing The Spreader Bar - Invacare AX3 Owner's Operator And Maintenance Manual

Hide thumbs Also See for AX3:

Table of Contents

SECTION 8—SEAT/BACK

Installing/Removing Seat Positioning Strap

NOTE: For this procedure, refer to FIGURE 8.8.

1. Remove seat cushion from wheelchair, if necessary.

2. Remove the mounting screw and locknut that secures the seat positioning belt half to

the wheelchair frame.

3. Repeat STEP 2 for opposite side, if necessary.

4. Do one of the following:

• To install the seat positioning strap, proceed to STEP 6.

• Remove the existing seat positioning strap from the wheelchair.

5. Engage the two halves of the new seat positioning strap.

6. Align the mounting holes on the wheelchair frame and one end of the new seat

positioning strap.

7. Secure the new seat positioning strap to the wheelchair frame with one mounting

screw and washer. Tighten securely.

8. Repeat STEPS 6 and 7 for the opposite side of the seat positioning strap.

9. Reinstall seat cushion onto wheelchair, if necessary.

Mounting Screw

Seat Positioning

Strap Half

Wheelchair Frame

FIGURE 8.8 Installing/Removing Seat Positioning Strap

NOTE: For this procedure, refer to FIGURE 8.9 on page 47.

NOTE: To remove the spreader bar, reverse this procedure.

1. Remove the end caps from the back canes.

2. Remove the handles from the back canes.

3. Install the inserts into the back canes.

4. Secure the insterts with mounting screws.

™

AX3

Wheelchair

NOTE: Seat upholstery removed for clarity.

Locknuts

Mounting Screw

Seat Positioning Strap Half

Part No 1143216

Table of Contents