Invacare Top End Crossfire T7A User Manual page 85

Adjusting Anti-tipper
WARNING
When anti-tippers are used, anti-tippers MUST be adjusted to maintain a 1-1/2 to 2-inch clearance between the bottom of
the anti-tipper wheels and the ground/ floor. This spacing should ALWAYS be checked whenever adjustments/changes are
made to the wheelchair. Failure to maintain proper spacing may result in the chair tipping over backward causing serious
injury or property damage.
1. Press in the lock button that secures the anti-tipper wheel assembly to the anti-tipper bar.
2. Adjust the height of the anti-tipper wheels to between 1-1/2 and 2-inches of the ground/floor.
3. Repeat STEPS 1-2 for the opposite anti-tipper.
Replacing Anti-tipper
WARNING
When anti-tippers are used, anti-tippers MUST be adjusted to maintain a 1-1/2 to 2-inch clearance between the bottom of
the anti-tipper wheels and the ground/floor. This spacing should ALWAYS be checked whenever adjustments/changes are
made to the wheelchair. Failure to maintain proper spacing may result in the chair tipping over backward causing serious
injury or property damage
1. Press in the release button that secures the existing anti-tipper to the anti-tipper bracket and remove the anti-tipper from the anti-tipper bracket.
2. Insert the new anti-tipper into the anti-tipper bracket until lock buttons protrude out of mounting hole.
3. Press in the lock button on the anti-tipper bar and install the anti-tipper wheels onto the new anti-tipper bar.
4. Repeat STEPS 1-3 for the opposite anti-tipper.
5. Measure the distance between the bottom of the anti-tipper wheels and the ground floor.
6. If necessary, adjust the height of the anti-tippers. Refer to Adjusting Anti-tipper on page 85.
Part No 1167484
.
85
12 ANTI-TIPPER
®
Invacare Crossfire™T7A Wheelchair