Table of Contents
Advertisement
11.10
Adjusting the Camber Tube
WARNING
Camber tube clamps - Make sure the clamp
screws are securely tightened before using the
wheelchair, otherwise injury or damage to the
wheelchair may occur.
Stand behind the wheelchair to determine left or
right.
1.
Loosen, but DO NOT remove, the socket head clamp screws in the
camber tube clamps (Detail "A").
2.
Using an "L" square, rotate the axle tube until the flat edge of the
camber tube is at a 90° angle with the ground/floor.
Ensure camber tube is centered between clamps.
This adjustment is made with the rear wheels
attached to the chair and all four wheels contacting
the floor.
If camber tube is not 0° degrees, then it MUST be
rotated so that the axle bushings are angled up at
their ends (FIGURE 13).
3.
Securely tighten the socket screw in the camber tube clamps (Detail
"A").
4.
Determine the toe in/toe out of the wheelchair. Refer to
Determining/Setting Toe In/Toe Out on page 76.
Part No 1167484
DETAIL "A" - SIDE VIEW
Camber Tube
Clamp
Ensure flat edge of camber
tube is parallel with vertical
edge of "L" square
Ground/
Floor
FIGURE 13
75
11 WHEELS
Socket Head Clamp Screw
Flat Edge of
Camber Tube
"L" Square
Adjusting the Camber Tube
®
Invacare
Crossfire™T7A Wheelchair
Advertisement
Table of Contents
