Invacare Top End Crossfire T7A User Manual page 69

Repositioning the Camber Tube Clamps
1. Remove the rear wheels. Refer to Removing/Installing Rear Wheels on page 62.
2. Loosen, but DO NOT remove, the four socket screws and washers that secure the two camber tube clamps to the camber tube supports.
3. Slide the camber tube forward or backward to adjust the wheelbase length to the desired position.
 Ensure that both camber tube clamps are adjust to the same position in the camber tube support. This will ensure that the camber
tube remains at 90° to each side frame.
4. Securely tighten the four socket screws and washers that secure the two camber tube clamps to the camber tube supports.
5. Install the rear wheels. Refer to Removing/Installing Rear Wheels on page 62.
Camber Tube Support
Camber
Tube Clamp
Part No 1167484
Socket Screws and
Washers
FIGURE 8 Repositioning the Camber Tube Clamps
69
11 WHEELS
Camber
Tube
®
Invacare Crossfire™T7A Wheelchair