Table of Contents
Advertisement
Removing Foldover Back Upholstery
1.
Unfasten the two fastening flaps that secure the bottom of the
existing back upholstery to the back canes.
2.
Unfold the top of the back upholstery.
3.
Lift up on the existing back upholstery and remove from the
wheelchair.
Installing Foldover Back Upholstery
1.
Install the new back upholstery onto the back canes.
2.
Wrap the end of a fastening flap around the back cane.
3.
Insert the end of the fastening flap through the loop.
4.
Wrap the fastening flap around the back cane again and press firmly
to secure.
5.
Fold the top of the back upholstery down over the back canes
towards the front of the wheelchair.
6.
Press firmly to secure the fastening strips.
8.5
Back Height Adjustment
Observe the tautness of the back upholstery for reinstallation.
1.
Remove the back upholstery cover and adjustable tension back upholstery. Refer to Removing/Installing the Back Upholstery Cover, Adjustable
Tension Back Upholstery and Lumbar Strap on page 49.
WARNING
Adjustment pin MUST be protruding through hole in back cane.
Ensure that both back cane inserts are at the same height BEFORE reassembling the wheelchair.
2.
Press the adjustment pin on the back cane insert tube in and adjust the back height to one of four heights depending on original back height:
Part No 1167484
Fastening Strips
Fastening Flap
FIGURE 9
Removing/Installing Foldover Back Upholstery
53
Back Upholstery
Front of
Wheelchair
Fold
Fastening Flap
Loops
Back Canes
®
Invacare
Crossfire™T7A Wheelchair
8 BACK
Advertisement
Table of Contents
