Table of Contents
Advertisement
Quad-Release Axle not
shown. Locking pins on the
Quad-Release Axle are the
same as Quick-Release
Axle.
11.2 Adjusting Quick-Release Axles
1.
Remove rear wheel and quick-release axle from the wheelchair.
Refer to Removing/Installing Rear Wheels on page 62.
2.
Depress detent pin in the quick-release axle and slide axle through
the wheel hub.
3.
Release detent pin ensuring that the locking pins are fully released.
4.
Increase or decrease end play by adjusting the locknut on the end
of the quick-release axle.
5.
Reinstall rear wheel onto the wheelchair. Refer to
Removing/Installing Rear Wheels on page 62.
Part No 1167484
Wheelchair Frame
Locking Pins
Quick-Release
Axle
Detent Pin
FIGURE 1 Removing/Installing Rear Wheels
63
Rear
Wheel
End of Quick Release axle is shown for reference
only. It is not visible when inserted into camber bar.
Adjustable Axle Position
Camber Bar
Locking
Pins
Quick-Release
Axle
FIGURE 2
Adjusting Quick-Release Axles
Invacare
11 WHEELS
Locknut
Detent
Pin
Wheel
Hub
®
Crossfire™T7A Wheelchair
Advertisement
Table of Contents
