Invacare Top End Crossfire T7A User Manual page 58

9 SEAT
• Moving bottom mounting screws to a new adjustment hole in the crescent link.
• Moving both mounting screws to a new adjustment hole in the crescent link.

Mounting screws in both crescent links MUST be adjusted to the same adjustment hole.
7. Once seat angle has been adjusted, install one washer and one locknut onto each mounting screw in the crescent links.
8. Securely tighten all four mounting screws and locknuts.
9. Securely tighten both mounting screws and locknuts that secure the front of the seat frame to the side frame.
10. Position wheelchair right side up.
11. Unfold back. Refer to Unfolding/Folding the Back on page 41.
12. Check for stability. Refer to on page 9.
Mounting
See Detail "A"
Screw
®
Invacare Crossfire™T7A Wheelchair
Locknuts and
Washers
Seat Frame
Side Frame
FIGURE 2 Seat Angle Adjustment
Mounting
Screw
Crescent
Side
Link
Frame
Mounting
Screw
58
DETAIL "A"
Mounting Screw
Adjustment
Holes
Part No 1167484