Converting Wheel Lock From Push-To-Lock To Pull-To-Lock Or Pull-To-Lock To Push-To-Lock - Invacare Top End Crossfire T7A User Manual

10.3 Converting Wheel Lock From Push-to-Lock to Pull-to-Lock or Pull-to-Lock to Push-to-Lock

Converting From Push-to-Lock to Pull-to-Lock
1. Remove set screw from the lower stop position (Detail "A").

As the wheel lock handle is pushed downwards, the wheel lock will engage and then disengage the wheel.
2. Push wheel lock handle down to access the upper stop position (Detail "B").
3. Install set screw into upper stop position.
4. Pull wheel lock handle up to engage wheel lock. If wheel lock does not properly engage the wheel, refer to Adjusting the Wheel Lock on page 59.
Converting From Pull-to-Lock to Push-to-Lock
1. Remove set screw from the upper stop position (Detail "B").

As the wheel lock handle is pulled upwards, the wheel lock will engage and then disengage the wheel.
2. Pull wheel lock handle up to access the lower stop position (Detail "A").
3. Install set screw into lower stop position.
4. Push wheel lock handle down to engage wheel lock. If wheel lock does not properly engage the wheel, refer to Adjusting the Wheel Lock on
page 59.
DETAIL "A"
WHEEL LOCK IN
PUSH-TO-LOCK
CONFIGURATION
FIGURE 3 Converting Wheel Lock From Push-to-Lock to Pull-to-Lock or Pull-to-Lock to Push-to-Lock
Part No 1167484
Wheel Lock
Handle
Set Screw
(in Lower Stop Position)
61
10 WHEEL LOCKS
Set Screw (in Upper Stop Position)
WHEEL LOCK IN
Wheel Lock
Handle
CONFIGURATION
®
Invacare Crossfire™T7A Wheelchair
DETAIL "B"
PULL-TO-LOCK