Table of Contents
Advertisement
11 WHEELS
4.
Remove the existing handrim.
5.
Install new handrim by reversing STEPS 2-4.
WARNING
DO NOT inflate tire until it is completely
assembled. Otherwise injury or damage may
result.
6.
Inflate tire to correct psi rating on the sidewall of tire.
7.
Reinstall rear wheel to the wheelchair. Refer to Removing/Installing
Rear Wheels on page 62.
8.
Repeat STEPS 1-7 for opposite rear wheel if necessary.
11.6 Repairing/Replacing Rear Wheel, Tire/Tube
WARNING
Replacement of the tire or tube MUST be performed by a qualified technician.
CAUTION
Changing the size of the rear wheels can affect the performance of the wheelchair. Contact Invacare at the numbers on the
back cover BEFORE performing this procedure.
If replacing rear wheels with a different size than what was originally on the wheelchair, the front caster height and/or diameter
MUST also be changed to keep the wheelchair frame parallel to the floor. Refer to Removing/Installing/Repositioning the Caster
Assemblies on page 79 ONLY after contacting Invacare. Anti-tipper height (if applicable) MUST also be adjusted to maintain 1-1/2
to 2-inch clearance between bottom of the anti-tipper wheels and the floor. Refer to Adjusting/Replacing Anti-tipper on page 84.
®
Invacare
Crossfire™T7A Wheelchair
Handrim
Locknut
FIGURE 5
66
Allen Screw
Handrim Replacement
Part No 1167484
Advertisement
Table of Contents
