Setup Using Ndps; Installing The Axis 5900 In An Ndps Environments - Axis 5900 User Manual

AXIS 5900 User's Manual

Setup using NDPS

Notes:

Installing the AXIS 5900 in an NDPS environments

Notes:
The AXIS 5900 supports Novell Distributed Print Services
(NDPS), which is Novell's new generation architecture for
printing and printer administration. You can run NDPS over
Pure IP (TCP/IP) or IPX/SPX.
Before the AXIS 5900 can be installed, make sure that NDPS is
installed and a Broker is loaded on your NetWare file server.
AXIS 5900 uses the AXIS NDPS Gateway for printing in
networks using either IP or IPX as transport protocols. The
printer gateways are included with the NDPS software (from
version 5.1 and up) and are automatically installed together with
NDPS.
• NDPS requires that you run NetWare 4.11 or higher.
• Pure IP is only supported by NetWare 5 or higher.
Having assigned an IP address to the AXIS 5900 as described in
Assigning an IP address to the print server, on page 21, you are
now ready to install the AXIS 5900 for NDPS printing. You can
select to install the connected printers as public or controlled
access printers. Follow the instructions below to install the AXIS
5900 using NDPS:
• The HP-JETADMIN parameter of the AXIS 5900 must be set to YES in order for
the communication between the AXIS 5900 and the NDPS gateway to be
enabled. Set this parameter in the print server's internal web pages: admin |
General Settings | HP JetAdmin Support (default value=NO)
• If you do not have an NDPS Manager object available, start out with creating
one in the NetWare Administrator.
Section 6 Setting Up - NetWare
59