Axis 5900 User Manual page 44

44
Section 5 Setting Up - Windows
Installing TCP/IP
printers in Windows
95/98/Me using
AXIS Print Monitor
1. To start the Add Printer Wizard, select Settings - Printers from
the Start Menu and double-click the Add Printer icon.
2. After clicking Next> in the first dialog, the Wizard asks you to
select between Local Printer and Network Printer. You must
select Local Printer as the AXIS 5900 emulates a local printer
port. Click Next>.
3. Choose the appropriate print driver for your printer. If the desired
print driver already appears within the displayed manufacturer
and model lists dialog, highlight your selection, click Next> and
proceed directly to step 6. It is only necessary to perform steps 4
- 5 if your printer does not feature in the model list.
4. Click the Have Disk... button. Insert the printer driver diskette
into the floppy disk drive of your computer. If the floppy disk
drive is A:/ then click OK, otherwise type the letter of your disk
drive and then click OK.
5. Select the desired printer you want to install from the diskette
and click Next>.
6. Select an AXIS Port you wish to use and then click OK. Available
AXIS ports appear as <internet address>_<port number> or
<host name>_<port number>, e.g. 192.36.254.101_9900. Click
the Configure Port button. If you wish to install a new TCP/IP
port, select the Printers@TCP/IP Port and perform all procedures
defined in steps 10-17.
7. Choose whether error condition pop-up messages are to be
displayed by checking the box in the Configure AXIS Ports dialog.
Define the frequency at which the error messages should be
displayed after retry. Click OK. Click Next>.
Note: The dummy port cannot be used for printing and
consequently cannot be configured.
8. Enter an appropriate name for your printer and click Next>.
9. Choose whether you wish to produce a Test Page and click Finish.
AXIS 5900 User's Manual