Adjusting Page Settings - Epson Stylus Pro 10600 Reference Manual

Mode
Drying Time
per Print Head
Pass
Paper Feed
Adjustment
Paper
Thickness
Paper Suction
Cut Method

Adjusting page settings

You can adjust the following settings on the "Paper Menu".
Orientation
Printable area
Description
Adjusts the Drying Time per Print Head Pass. Use a value
in the range of 0 to +50 (5.0sec), in 0.1sec increments.
Drag the scroll bar to the right or left with your mouse to
adjust the setting. You can also type a number (0 to +50)
in the box next to the slide bar.
Adjusts the amount of Paper Feed Adjustment. Use a
value in the range of -70 to +70. The units are 0.01%. Drag
the scroll bar to the right or left with your mouse to adjust
the setting. You can also type a value (-70 to +70) in the
box next to the slide bar.
If you adjust the setting, try at least a 6 unit difference from
the prior value, to create a visual difference on the
sample print.
Enter the Paper Thickness value in the range of 0 to +15.
You can specify a value in the range of 0 to 1.5mm, in
0.1mm increments.
Adjusts the Paper Suction value. You can select from
Standard (100%), -1(50%), -2(30%), -3(10%) or -4(6%).
For thin media, reducing the value will help paper
feeding.
From the pop-up menu, select a Cut Method for thin
paper. You can select from Standard, Thin Paper or Very
Thin Paper.
Use this setting to specify the direction of printing on
the page: Portrait (vertical), or Landscape
(horizontal). If you need to print close to the bottom
of the page, click Rotate by 180°.
Select Centered to position your printout at equal
distances from the edges of the paper. This setting is
available only for sheets.
-119