Epson Stylus Pro 10600 Reference Manual page 253

PAPER NOT STRAIGHT
Paper Out
RELOAD PAPER
Paper Out
LOAD PAPER
Paper Out
REMOVE PAPER
Paper Out
-252
Slippage occurred
and paper was fed
at an angle.
Paper could not be
reversed into the
printing position.
Paper is set out of the
printable area.
Paper is set out of the
horizontal cutting
area.
Paper is not fully
ejected.
PAPER NOT CUT error
was cleared.
Optional Auto
Take-up Reel Unit is
not operating
correctly.
Paper lever was
released during the
printing process or
another operation.
Loaded paper is too
thick for head
cleaning.
Reload paper. See
"Paper Feed or Paper
Jam Problems Occur
Frequently".
Remove then reload the
paper so that the right
and bottom edges are
straight and in line with
the rows of punch holes
on the printer. See
"Paper Handling".
Cut the paper at the
paper insertion slot, then
reload paper.
Reload paper.
Check whether the unit is
operating correctly. See
"Troubleshooting on the
Optional Auto Take-up
Reel Unit".
Set the paper lever to the
secured position. Start
printing again from the
beginning for best results.
Push the paper lever
down to remove the
paper. Head cleaning
automatically starts.
After cleaning, PAPER OUT
is displayed. Reload
paper.