Epson Stylus Pro 10600 Reference Manual page 67

INK LOW
NO INK CARTRIDGE
DEFECTIVE INK CRTG
COMMAND ERROR
OPTION I/F ERROR
SERVICE REQ
nnnnnnnn
MAINTENANCE REQ
nnnn
TURN PWR OFF AND
ON
CLOSE INK COVER
NOZZLE CHECK
ERROR
WRONG
CARTRIDGE
INVALID CARTRIDGE
NOT ENOUGH INK
UNABLE TO PRINT
-66
Ink cartridge(s) is (are) nearly empty. Replace the
ink cartridge(s) indicated by the Ink Out light(s).
When the ink cartridge(s) is (are) out, printing stops.
Printing can be resumed after empty cartridge(s)
has (have) been replaced.
You are replacing the ink cartridge(s).
CSIC error has occurred. Remove the cartridge
and reinstall it.
This message is displayed in the following cases:
1. When the installed printer software is not correct
for your printer.
2. When damaged data is sent to the printer while
using the photo printing accelerator.
3. When the printer receives data with a wrong
command sequence for ESC/P2.
A Type-B I/F error has occurred.
A fatal error has occurred.
A part used in the printer has nearly reached the
end of its service life. Note the error number nnnn
and contact your dealer. See "Contacting
Customer Support".
After clearing jammed paper, this message
appears. Turn the printer off and on.
The ink compartment cover is open. Close the
cover.
Correct test printing is not printed while Auto Nozzle
Check is performed.
This message is displayed when a wrong type of ink
cartridge is installed.
This message is displayed if an ink cartridge with the
wrong product number is installed.
The ink remaining is not enough to finish cleaning.
No paper is loaded when printing a pattern, such
as a nozzle check pattern.