Troubleshooting On The Optional Auto Take-Up Reel Unit - Epson Stylus Pro 10600 Reference Manual

Troubleshooting on the Optional Auto
Take-up Reel Unit
Try one or more of these solutions:
❏ The roll paper may not have sufficient slack around the auto
take-up reel unit. Make sure that there is adequate slack
between the roll paper and the take-up reel core. See "Loading
roll paper onto the take-up reel core".
❏ The Auto switch on the auto take-up reel unit may not be
positioned for the direction you want. Select a direction using
the Auto switch on the control box. See "Taking-up your
prints".
❏ If the sensor light flashes slowly when you are not printing,
there may be an external obstruction between the emitter and
detector, or sensor adjustment may not be set properly. Check
for an obstruction in the sensor detection area, or adjust the
sensor position. See "Adjusting the sensor".
❏ If the sensor light is still flashing, the printer will print the job
for approximately three meters and stop printing. Set the
paper lever to the released position, then check that the roll
paper is set properly and that there is no external obstruction
in the sensor detection area. If the roll paper is not set
properly, wind the excess paper up and set the paper lever to
the secured position.
❏ If the sensor light is flashing rapidly, the auto take-up reel unit
is locked. Turn the printer off and on again.
❏ If the sensor light is off, the sensor cable may not be connected
properly. Check the connection of the sensor cables.
-272