The Printer Does Not Turn On Or Stay On - Epson Stylus Pro 10600 Reference Manual

The Printer does not Turn on or Stay on

Message and Light
PAPER OUT
Paper Out
LOAD ROLL PAPER
LOAD SHEET PAPER
Paper Out
PAPER JAM
Paper Out
FRONT COVER OPEN
PAPER NOT CUT
Paper Out
Problem
No paper is loaded in
the printer.
Paper ran out.
The paper source
setting in the printer
driver is different from
the control panel.
Paper is jammed in
the printer.
Front cover is open.
Roll paper was not
cut.
Cut paper did not fall
off.
Solution
Load paper in the printer.
Remove any printouts or
paper remaining in the
printer. Load more
paper.
If this message appears
during a print job, reset
the printer by pressing
the Pause button for 3
seconds, then load
paper and send the job
again.
Make sure the paper
source setting in the
printer driver is the same
as the control panel.
Remove the jammed
paper. See also "Paper
Feed or Paper Jam
Problems Occur
Frequently".
Close the front cover.
Cut the paper manually,
then remove the cut
paper from the printer.
When RELOAD PAPER is
displayed, load paper.
Remove the cut paper
from the printer. When
RELOAD PAPER is
displayed, load paper.
-251