Using The Roll Paper Belt - Epson Stylus Pro 10600 Reference Manual

Note:
If the Roll Auto Cut light is on, and the bottom edge of the roll
paper was not cut properly after the previous print job, press the
Cut/Eject button to recut the edge.
9. Press the Pause button.
The print heads move and the paper feeds into the printing
position automatically. READY appears on the LCD panel.
Note:
Even if you do not press the Pause button, the print heads move
and paper feeds into the printing position automatically. READY
appears on the LCD panel.
10. Make the printer driver settings (see "Basic Settings" for
Windows or "Basic Settings" for Macintosh), then send a print
job from the computer. The printer starts printing.
Note:
Make sure that the Paper Source setting in the printer driver
matches the paper loaded in the printer.
11. After you finish printing, you may need to cut the roll paper.
See "Cutting roll paper or printing page lines".

Using the roll paper belt

If you use the roll paper belt for the 2-inch roll paper spindle, tap
the end of the roll paper belt lightly on the roll paper. The belt will
wrap itself around the roll paper. If you use the roll paper belts
for 3-inch roll paper spindle, slide the belt end through the ring
and fasten the roll paper.
-201