Table of Contents
Advertisement
3
CONNECTIONS
AC Power (mains) Cord Connection
Use the supplied power cord to connect your projector to
the wall outlet. Plug the female power connector into the
male connector at the backside of the projector.
Power Check
The power voltage is determined by the art. no., listed on sticker on
the back side of the projector.
Warning !
Verify the power voltage corresponds to that of the wall outlet.
Art. No. R9002031 must be connected to a 230 VAC power source.
Art. No. R9002038 must be connected to a 120 VAC power source.
If the wall outlet voltage is different, call a qualified technician for
power adaptation of the projector.
Switching On/Off
The projector is switched ON and OFF using the power (mains) switch
ON/OFF.
Pressed : ON
Not pressed : OFF
The projector can start in the 'operational mode' (image displayed) or
in the 'stand by mode', depending on the position of the 'power up' dip
switch on the controller unit. This DIP switch must be set during
installation by a qualified technician. If you want to change this start
up mode, call a qualified technician.
Stand by indication lamp :
No light up : projector switched off
Green color : projector in Operational mode
Red color : projector is in Standby mode.
5975597 BARCODATA 808S 110397
See installation instructions before connecting to the supply.
Voir la notice d'installation avant de raccorder au réseau.
120/230 V
7/5 Amp
50/60 Hz
PORT 4/5
PORT 2
RS232 IN RS232 OUT IR REMOTE
IN
RS232
OUT
RS232
IR REMOTE
green : operation
VIDEO
OFF - ON
75 Ohm
red : standby
PORT 1
PROJECTOR MODE
Connections
Th is d evice co mp li es w it h part 15 of
th e FCC ru les. Op erati on i s su bj ect to
fo llo win g two co ndi tio ns (1). Th is
d evice may n ot cau se harmf ul i nt er-
f eren ce, an d ( 2) t hi s d evice mu st
accep t any in terf erence received
i nclu di ng i nt erferen ce t hat may cause
un desi red op erat io n"
75 Ohm
75 Ohm
120/230 V
7/5 Amp
50/60 Hz
This device complies with part 15 of
the FCC rules. Operation is subject to
following two conditions (1). This
device may not cause harmful inter-
ference, and (2) this device must
accept any interference received
including interference that may cause
undesired operation"
3-1
Advertisement
Table of Contents
