Table of Contents
Advertisement
2
LOCATION AND FUNCTION OF CONTROLS
REAR PANEL TERMINOLOGY
See installation i nstru ction s befo re co nnecting to the supp ly.
Voir la notice d'installation avant de raccorder au réseau.
120/230 V
7/ 5 Amp
50/60 Hz
1
2
3
Power Switch : Press the switch to turn the projector ON.
1
Depending on the hardware set-up of the projector during
installation, the projector switches to 'Standby' or to 'Op-
erational' mode. If in standby, the standby LED lights up.
2
AC Power Input
Communication Port (800 peripherals)
3
* Allows communication between the RCVDS switcher and
the projector.
* Allows connection of a remote IR receiver unit to the
projector.
Port 3
4
RGB Analog Input (9 pin female sub D connector). Allows
a character generator, microcomputer, etc. having analog
RGB outputs to be connected to the projector.
Port 4/5 : RGB-S Input (5x BNC connector):
5
RGB-S input : allows a character generator, microcomputer,
video camera, etc. having analog RGB output to be con-
nected to the projector.
Line inputs:
- signals RED-GREEN-BLUE
- COMPOSITE sync. signal
- Tri level sync signal (option)
FRONT PANEL TERMINOLOGY
RS232 IN RS232 OUT IR
REMOTE
IN
RS232
OUT
RS232
IR REMOTE
11
12
13
14
RS 232 Input Port
11
Connection between the BARCODATA 808 and an IBM PC
(or compatible) or MAC (RS422) for remote computer
control and data communication.
RS 232 Output Port
12
RS 232 Output Port allows a communication link for PC or
MAC to the next projector in a series of projector.
5975597 BARCODATA 808S 110397
75 Ohm
PORT 4/5
PORT 2
4
5
6
7
This device complies with part 15 of
the FCC rules. Oper ation is sub ject to
following two cond itions (1). This
device may no t cause h armful inter-
feren ce, and (2) this device must
accept any interf eren ce received
including interference that may cause
undesired operation"
75 Ohm
10
8
9
S-VIDEO Input: Separated Y/C (luma-chroma) signal in-
6
puts and outputs for higher quality playback of Super VHS
signals (4-pin S-VIDEO connector loop-through).
7
75 ohm Termination Switch for S-Video signals
VIDEO Input (Composite video, 2x loop-through BNC
8
connector): Allows a video tape recorder, video camera,
color receiver/monitor, etc. having video line output to be
connected to the projector.
9
75 ohm Termination Switch for Video signals
Projector Pilot Lamp : Indicates the status of the projector.
10
- Unlit : mains (power) switch is not pressed.
- Lit : mains (power) switch is pressed and the indicated color
shows the projector mode:
Green color : Operational mode of the projector.
Red color : Standby mode of the projector.
Important : Projector ("Operational" or "Standby") mode is
defined during the installation of the projector. (Refer to a
qualified technician for change).
IR Sensor
13
Receiver for control signals transmitted from the RCU.
IR Remote
14
Connector for remote input for hard wired remote control
Location and Functions of Control
2-1
Advertisement
Table of Contents
