Table of Contents
Advertisement
Speco Technologies
click 'Enter',
Check if IP Setting is correct or not, referring to 'Video Check'
If Video is seen, THE CAMERA has been correctly set up.
If Video is not seen, check whether there may be a conflict of IP in the Network,
and re-check the set value of Network environment of THE CAMERA, and
Network environment of User's PC.
3.2.2.
Dynamic IP Setup
Do not set up Dynamic IP in the camera except as a direct connection
of Cable Modem supporting Dynamic IP with the camera.
Reset, in case IP has not been allocated to THE CAMERA in Dynamic
IP Setting, to go to Initial Value and try again.
1)
After checking Video in 'Video Check', then go to the next step.
2)
Connect THE CAMERA and LAN Cable (Cross Cable)
3)
Cable Connection and Network Setting should be done same as per
Check'.
4)
Go to Network Setting Page of Administrator's Page as per 4), 5), 6), 7) of 'Static IP
Setup'.
IP Camera User's Manual
31
'2. Install and Video
Advertisement
Table of Contents
