Speco Technologies
device. We recommend to use a IP router (IP Sharing device) to install the THE CAMERA. There may be
a case in no need of router, but most people use THE CAMERA and other PC 1set or more. When using
the router, connect the router and input IP address of THE CAMERA (IP address of THE CAMERA is set
as 192.168.1.7 on ex-factory) in DMZ menu. If the user cannot use the DMZ function because there is no
DMZ menu in the router or some other reasons, go into port forwarding or NAT menu on the router and
map the port of THE CAMERA one by one. User can check the current port setting of THE CAMERA from
"Administrator's Page"->"Network Setting"->"Port Setting" (see
of THE CAMERA is as follow on ex-factory : (The user can change port if necessary).
Web Connection Port : Port 80 TCP
Authentication and Control Port
Video Streaming Port : Port 9001 TCP
Motion Detectin Control Port
IP Camera User's Manual
'3. Basic
Setting'). Manufacturer's setting
: Port 9000 TCP
: Port 9005 TCP
113