Table of Contents
Advertisement
area settings.
Statistics: If enabled, you can see the statistical information of human, motor vehicle and non-motor vehicle in the live view
interface.
The statistical OSD information can be customized as needed.
4.
Advanced settings. Click the "Advanced" tab to enter the advanced setting interface. Select the recognition mode as needed.
Interval mode and instant mode can be selectable.
Interval mode: the system will push the captured picture to the live interface according to the set interval time.
Instant mode: the system will push the captured picture immediately once a target is detected.
5.
Select the attribute information of the target. Click "Image OSD" and then select the relevant attribute information. When the
target is detected, the information you select will be displayed in the attribute display area. See Video Metadata View for details.
6.
Set the schedule of video metadata function. The setup steps of the schedule are the same as schedule recording setup (See
Schedule
Recording).
After all settings above are configured, return to the live interface to view the captured pictures and features.
Video Metadata View
In the live interface, click
Human body information will be shown on the right panel.
Motor vehicle and non-motor vehicle information will be shown on the left panel.
Click the captured picture to view the detailed information, including original picture, target picture and detailed attributes.
A maximum of 1,000 captured pictures can be shown on the live interface. If exceeded, the previous captured pictures will be
overwritten.
4.5 Network Configuration
4.5.1 TCP/IP
Go to NetworkTCP/IP interface as shown below. There are two ways for network connection.
to view the following smart snapshots.
39
Advertisement
Table of Contents
