Network Configuration; Tcp/Ip - Speco O4iT2W User Manual

Select the report type. Daily report, weekly report, monthly report and annual report are selectable.
Select the count type. Enter or leave can be optional.
Select the start time and then click "Count". Then the counting result will display in the statistic result area. Click Table or Chart to
display the result in different way.

4.5 Network Configuration

4.5.1 TCP/IP

Go to NetworkTCP/IP interface as shown below. There are two ways for network connection.
Use IP address (take IPv4 for example)-obtain a local IP address automatically through DHCP. A typical router has a DHCP server
built in, and therefore is able to assign an IP address to the camera.
Use PPPoE-Click the "PPPoE Config" tab to go to the interface as shown below. Enable PPPoE and then enter the user name and
password from your ISP.
Either method of network connection can be used. If PPPoE is used to connect internet, the camera will get a dynamic WAN IP
address. This IP address will change frequently. To be notified, the IP change notification function can be used.
Click "IP Change Notification Config" to go to the interface as shown below.
29