shown below. The default heat map is people flow data display. Click "Motor Vehicle" or "Non-motor Vehicle" to view the
corresponding data.
4.5 Network Configuration
4.5.1 TCP/IP
Go to NetworkTCP/IP interface as shown below. There are two ways for network connection.
Use IP address (take IPv4 for example)-obtain a local IP address automatically through DHCP. A typical router has a DHCP server
built in, and therefore is able to assign an IP address to the camera.
Use PPPoE-Click the "PPPoE Config" tab to go to the interface as shown below. Enable PPPoE and then enter the user name and
password from your ISP.
35