Click the "Draw Area" button and then click around the area where you want to set as the alarm area in the image on the left side
(the alarm area should be a closed area). Click the "Stop Draw" button to stop drawing. Click the "Clear" button to delete the alarm
area. Click the "Save" button to save the settings.
3. Set the schedule of heat map. The setup steps of the schedule are the same as schedule recording setup (See
Schedule
Recording).
4. View the heat map data (click ChartHeat Map). Set the start time and the end time. Click "Count" to view the heat map as
shown below. The default heat map is people flow data display. Click "Motor Vehicle" or "Non-motor Vehicle" to view the
corresponding data.
4.5 Network Configuration
4.5.1 TCP/IP
Go to NetworkTCP/IP interface as shown below. There are two ways for network connection.
34