D6600/D6100Ipv6 Operation; Process Flow; Receiver Handshake And Kiss-Off; Message Verification - Bosch Conettix D6600 Installation And Operation Manual

Conettix Communications Receiver/
Gateway
11

D6600/D6100IPv6 Operation

11.1

Process Flow

11.1.1

Receiver Handshake and Kiss-Off

The telephone line dialed by the communicator connects to a line card in the D6600/
D6100IPv6. The line card detects ringing voltage, answers the incoming call, and sends a
programmed series of handshake tones. The communicator detects the expected handshake
and transmits its message. The receiver sends the kiss-off after the receiver receives and
understands the communicator's message.
Program the receiver for up to eight handshake attempts, using any combination of the
available handshake tones.
With Handshake Optimization enabled, the D6600 can send the appropriate Handshake Tone
(associated with the Caller ID number in the Caller ID database) to the control panel or a
Dialed Number Identification Service (DNIS) database can be created to optimize the
handshake outputs and other line card parameters.
Notice!
i
The D6600 can use only one database (DNIS or Caller ID) at a time. The D6100IPv6 does not
have this feature.
11.1.2

Message Verification

The D6600/D6100IPv6 checks each message for errors. If the receiver receives the data
correctly, it sends the kiss-off acknowledgment tone to the communicator. The communicator
hangs up and returns the subscriber's telephone line to normal.
If the data is not correct, the receiver withholds the kiss-off tone and prints an error message
refer to No Data Received Reports, causing the communicator to send the information again. If
the receiver still does not receive the data correctly after the communicator's set number of
retransmissions, the communicator hangs up. The communicator restarts the signal process
and attempts to transmit another message. The communicator repeats this process until the
receiver receives the kiss-off tone or until the maximum number of dialing attempts is
depleted.
11.1.3

Handshake Tone Compatibility

When the D6600/D6100IPv6 answers an incoming line, it waits for a programmed time before
transmitting the handshake tone(s).
Notice!
Some communicators wait approximately 30 sec for the proper handshake tone. Others hang
up immediately if they hear an improper handshake tone. Others have a very short handshake
i
wait time.
To eliminate waiting through a sequence of handshake tones, program the line card so that
the first handshake tone transmitted is compatible with existing equipment.
The D6600/D6100IPv6 can receive incoming signals while transmitting handshakes.
11.1.4

Message is Received

The receiver can process messages from all available telephone lines simultaneously. The
messages print and appear one by one, as the previous message clears from the display.
Bosch Security Systems, Inc. Installation and Operation Guide
D6600/D6100IPv6 Operation | en
2012.11 | 08 | 4998122704
33