Bosch Conettix D6600 Installation And Operation Manual page 62

62 en | Network Communications
Config Config
Section Sub-
section
interface eth0
interface eth0
interface eth0
interface eth0
interface eth0
oem
device
device
bosch tunnel 1 or 2
bosch tunnel 1 or 2
bosch tunnel 1 or 2
2012.11 | 08 | 4998122704
Config Default
Parameter Value
default <None
gateway >
dhcpv6 enable
ipv6 <None
address >
ipv6 <None
default >
gateway
hostname
mac
address
short D6686
name
long name Bosch
D6686
local port 7700
(tunnel
1) / 7701
(tunnel 2)
protocol UDP
aes key 128
size
Installation and Operation Guide
Valid Values Description
Accepts in If IPv4 DHCP is disabled, enter the IPv4
IPv4 address Gateway IP Address.
in dotted
notation
(192.168.1.1)
enable, disable Determines if IPv6 DHCP is used. If this is set
to disabled, then a Static IPv6 Address needs
to be specified in the IP Address
Configuration Parameter.
Accepts an If IPv6 DHCP is disabled, then an IPv6
IPv6 address Address must be entered here.
Accepts an If IPv6 DHCP is disabled, enter the IPv6
IPv6 address Gateway IP Address.
in colon
notation
(2001:0db8:85
a3:0042:0000:
8a2e:
0370:7334)
Sets the hostname that is used with DHCP.
Allows for an alternate MAC Address to be
entered here supporting the failover
configuration described in the D6600/
D6100IPv6 I&O Guide (4998122704).
Sets the product short name displayed in
command mode. (Max of 8 Characters)
Sets the product long name displayed in
command mode.
IP Port number the D6686 is listening on for
IP traffic relative to each serial port. See the
failover configuration described in the D6600/
D6100IPv6 I&O Guide (4998122704).
UDP, UDP AES Determines the protocol to be used
depending whether encryption is being used.
(See Important Note on next page)
128, 192, 256 Determines the Encryption Key Size in
number of bits.
Conettix Communications Receiver/
Gateway
Bosch Security Systems, Inc.