6.8
Flying a DME Arc Approach
Approaches that contain DME arcs are supported by the GTN. The GTN will
provide guidance (left / right) relative to the arc. If you wish to activate the DME
arc leg manually, the aircraft must be near the arc, as shown in the shaded area
below.
6.9
Vectors to Final
With "Vectors-To-Final" (VTF) selected, the CDI needle remains off center
until you're established on the final approach course. With the approach
activated, the Map Page displays an extension of the final approach course in
magenta (remember, magenta is used to depict the active leg of the flight plan)
and "vtf" appears as part of the active leg on the Map page (as a reminder that
the approach was activated with vectors-to-final).
NOTE: Once VTF is activated all waypoints in the approach prior to the FAF
are removed.
190-01004-03 Rev. F
Figure 6-22 DME Arc Example
Garmin GTN 625/635/650 Pilot's Guide
Foreword
Getting
Started
Xpdr Ctrl
Com/Nav
FPL
Direct-To
Proc
Wpt Info
Map
Traffic
Terrain
Weather
Nearest
Services/
Music
Utilities
System
Messages
Symbols
Appendix
Index
6-13