Displaying And Operating Traffic (Tas Systems); Switching From Standby Mode To Operating Mode - Garmin GTN 625 Pilot's Manual

9.4.2
Foreword
Getting The unit must be in operating mode for traffic to be displayed. The ability
Started
to switch from standby to operating mode on the ground is especially useful for
scanning the airspace around the airport before takeoff.
Xpdr Ctrl
Com/Nav
FPL
Direct-To
Traffic Status Key
Proc
(Operate/Standby)
Wpt Info
Map
9.4.2.1
Traffic
The Traffic Page shows surrounding TAS traffic data in relation to the aircraft' s
Terrain
current position and altitude without basemap clutter. Aircraft orientation is
always heading up unless no valid heading is received. The Traffic Status is
Weather
shown in the lower left corner and the Altitude Filter is shown in the lower right
corner.
Nearest
Services/
Music
Utilities
System
Messages
Symbols
Appendix
NOTE: Not all TAS systems can be set to "Standby" mode while in the air.
Index
9-14
Displaying and Operating Traffic
(TAS Systems)
Non-Threat
Traffic
Figure 9-8 Traffic Page

Switching from Standby Mode to Operating Mode

1. While viewing the Traffic Page, touch the Traffic Status key
to select Operate.
2. To switch to Standby Mode from the Traffic Page, touch the
Traffic Status key to select Standby.
3. The Altitude Filter limits the traffic displayed to the Below,
Normal, Above or Unrestricted altitude block as listed in the
"Displayed Traffic Range" table. The filter altitudes are relative
to ownship altitude. Touch the Altitude Filter key to change
the altitude filter value.
4. Touch the Traffic Status key to place the system in the Standby
mode. Standby is displayed in the Traffic mode field.
Garmin GTN 625/635/650 Pilot's Guide
Traffic Proximity
Advisory
Ownship
Position
Heading
Annunciation
Range Rings
Altitude Filter
190-01004-03 Rev. F