Garmin GTN 625 Pilot's Manual page 106

6.2
Foreword
A Departure Procedure (DP) is loaded at the departure airport in the flight
plan. Only one departure can be loaded at a time in a flight plan. If a departure
Getting
Started
is loaded when another departure is already in the active flight plan, the new
departure replaces the previous departure. The route is defined by selection of a
Xpdr Ctrl
departure, the transition waypoint, and a runway.
Com/Nav
NOTE: Vector-only departures are not available in the Procedures database
as the GTN 6XX cannot provide navigational guidance on vectored legs.
FPL
Direct-To
Proc
Wpt Info
Map
Traffic
Terrain
Weather
Nearest
Touch To Select
Desired Departure
Services/
Music
Utilities
System
Messages
Touch To Select
Desired Departure
Symbols
Appendix
Index
6-4
Selecting a Departure
1. Touch the PROC key on the Home page and then touch the
Departure key to display the Departure list.
Touch To Show
Departure List
Figure 6-2 Select Departure
2. If necessary, touch the Airport key and enter the departure
airport. Touch the key for the desired Departure.
3. Touch the key for the desired Transition.
Transition
Figure 6-3 Selecting a Departure Transition
4. Touch the key for the desired Runway, if necessary.
Runway
Figure 6-4 Selecting a Departure Runway
Garmin GTN 625/635/650 Pilot's Guide 190-01004-03 Rev. F