Tcp/Ip Menu - Lexmark C746x User Manual

Understanding printer menus
Use
Job Timeout
0, 10–255 seconds
Banner Page
Off
On

TCP/IP menu

Note: This menu is available only in network models or printers attached to print servers.
To access the menu, navigate to any of the following:
•
Network/Ports > Standard Network > Standard Network Setup >TCP/IP
•
Network/Ports > Network [x] > Network [x] Setup >TCP/IP
Use
Activate
On
Off
Set Hostname
IP Address
Netmask
Gateway
Enable DHCP
On
Off
Enable RARP
On
Off
Enable BOOTP
On
Off
Enable Auto IP
Yes
No
To
Set the amount of time it takes for a network print job to be canceled.
Notes:
•
90 seconds is the factory default setting.
•
A setting value of 0 disables the timeout.
•
If a value of 1–9 is selected, then the setting is saved as 10.
Allow the printer to print a banner page.
Note: Off is the factory default setting.
To
Activate or deactivate TCP/IP.
Note: On is the factory default setting.
Set the current TCP/IP host name.
Note: This can be changed only from the Embedded Web Server.
View or change the current TCP/IP address.
Note: Manually setting the IP address sets the Enable DHCP and Enable Auto IP
settings to Off. It also sets Enable BOOTP and Enable RARP to Off on systems that
support BOOTP and RARP.
View or change the current TCP/IP netmask.
View or change the current TCP/IP gateway.
Specify the DHCP address and parameter assignment setting.
Note: On is the factory default setting.
Specify the RARP address assignment setting.
Note: On is the factory default setting.
Specify the BOOTP address assignment setting.
Note: On is the factory default setting.
Specify the Zero Configuration Networking setting.
Note: Yes is the factory default setting.
150