ATCOM at810 User Manual page 32

AT810 Series User Manual
5.5.1.5 Data And Time
 NTP
1. NTP Server: Network time protocol service server, default is pool.ntp.org.
2. Time Zone: Choose the time zone.
3. Daylight Saving Time: Whether to enable Daylight saving time or not.
4. Daylight Saving Time Rule: This parameter is a rule with three fields, each field is
separated by semicolon, as show below:
Start=<start-time>; end=<end-time>; save=<save-time>
<start-time> and <end-time> specify the start and end date of daylight saving
time, month/date/week and <save-time> is the amount of hour/min/sec to add
to the current time during daylight saving period. The <save-time> value can be
preceded by a negative (-) sign if subtraction is desired instead of addition.
If <weekday > is 0, it means the date to start or end daylight saving is at exactly
the given date. In that case, the <day> value must not be negative.
If<weekday >is not zero, then the daylight saving starts or ends on the
<weekday >on or after the given date if <day> is positive, or on or before the
given date if <day> is negative. If <day> is -1, it means the <weekday> on or
before the end-of-the-month (in other words the last occurrence of <weekday>
in that month).
Optional values inside [] are assumed to be 0 if they are not specified. Midnight
means 0:0:0 of the given date.
E.G. start=4/1/7/8:00:00;end=10/1/7/9:00:00;save=-1
Start time is 1st April, Sunday, 8:00:00 am.
End time is 1st October, Sunday, 9:00:00 am.
The display time will be 1 hour early than the standard time.
 Manual
1. Set Local Date (YYYY/mm/dd): Manually set local date.
2. Set Local Time (HH:mm:ss): Manually set local time.
ATCOM TECHNOLOGY CO., LIMITED www.atcom.cn
32