Table of Contents
Advertisement
Chapter 7
About Connected Grid Modules
Install Modules
Tip
This section provides general module installation steps. For detailed steps for the module type that you
are installing, see the installation and configuration guide for your module at:
www.cisco.com/go/cgr1000-docs.
To install a module in an available router slot, follow these steps:
Step 1
Power down the router as described in the router hardware installation guide on Cisco.com, at:
www.cisco.com/go/cgr1000-docs.
Insert the module in the slot as shown in
Step 2
Step 3
Using a screwdriver, secure the module captive screws (two per module) into the connectors on the router
front panel.
Power on the router as described in the router hardware installation guide on Cisco.com, at:
Step 4
www.cisco.com/go/cgr1000-docs.
Figure 7-1
1
2
3
4
3-Phase AC Power
OL-26438-02
Insert Modules into Router
5
Figure
7-1.
1
2
3
Single-Phase AC Power
Cisco 1120 Connected Grid Router Hardware Installation Guide
Installing Modules in the Router
7-3
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Cisco ASR 5000 Application Detection and Control Administration Guide and is the answer not in the manual?
Questions and answers