Console Port - Cisco ASR 5000 Application Detection and Control Administration Guide Hardware Installation Manual

Hardware Features
The ports are labeled as follows:
•
•
Specifications
Specification
Connector type
Cable
Signaling
Max. drivers
Max. receivers
Operating mode
Network topology
Max. distance (standard)
Max speed
(at 12 m/1200 m)
Pinouts

Console Port

See
The router features a single asynchronous console port for connecting a console or PC directly to the
router. To configure the router locally, using the command-line interface (CLI), you must establish a
connection to the router with a terminal session.
The router also supports wireless console connections with an internal
Note
Console Port Default Settings
The console port does not support hardware flow control. The default settings for the port are:
9600 baud, 8 data bits, no parity, and 1 stop bit.
Connecting to the Console Port
Detailed information about connecting to the console port is in the chapter
Connections.
Cisco 1120 Connected Grid Router Hardware Installation Guide
3-16
SER 1/1
SER 1/2
Figure 3-5 for the console port location.
RS232
DB-9
You must order a serial transition cable for the signaling protocol.
Single-ended
1
1
Full duplex
Point-to-point
15 m
20 Kbps/1 Kbps
See Connector and Cable Specifications
Chapter 3 Router Hardware Description
RS485
Differential
32
256
Half duplex
Full duplex
Multipoint
1200 m
35 Mbms/100 Kbps
Short-Range Access Point.
Making Network
OL-26438-02