Inserting the SD Card
Supported SD Cards
Table 9-1
Table 9-1
Size
2-GB
For detailed specifications about the SD flash memory module, refer to
Note
Accessing the SD Card
The SD card is accessed from the router exterior, though the router SD card port, shown in
Caution
Removing the SD card during normal router operation will cause the router to stop operating. Do not
remove the SD card while the router is operating.
Figure 9-1
Inserting the SD Card
Depending on the configuration, the router could arrive in the shipping container with the SD card
already installed.
However, you might need to install an SD card in the router when:
•
Cisco 1120 Connected Grid Router Hardware Installation Guide
9-2
lists the SD cards that can be used with the router.
Supported SD Flash Memory Modules
SD Card Slot (with Cover) on Router Exterior
You are upgrading the router with software or firmware stored on the SD card.
Chapter 9
Using the SD Flash Memory Module
Router Hardware
SD card slot
Description.
Figure
9-1.
OL-26438-02