Connected Grid Module Slots - Cisco ASR 5000 Application Detection and Control Administration Guide Hardware Installation Manual

Hardware Features
Dimensions
+.26
3.00
–.00

Connected Grid Module Slots

The router has two module slots to support up to two compatible Cisco Connected Grid modules that add
NAN and LAN interfaces to the router.
•
•
Module Numbering
The router uses module numbering to identify the integrated and modular router components. Some
system software commands refer to the following module numbers.
•
•
•
Cisco 1120 Connected Grid Router Hardware Installation Guide
3-10
7.00
4 * R 1.00 max
For more information about the Connected Grid modules for this router, see the chapter
Connected Grid Modules.
For detailed installation instructions for installing Cisco Connected Grid modules in the router, see
the corresponding installation and configuration guide for each module at:
www.cisco.com/go/cg-modules
Module 1 is the integrated router supervisor engine (located on the CPU motherboard)
Module 2 is the router integrated Ethernet switch module, which has six Fast Ethernet ports and two
Gigabit Ethernet ports.
Module 3 and Module 4 are external, Connected Grid modules installed in the router module slots
with the corresponding numbers (see
+.26
–.00
Figure 3-4).
Chapter 3 Router Hardware Description
About
OL-26438-02