Power Cycling The Router; Accessing The Buttons - Cisco ASR 5000 Application Detection and Control Administration Guide Hardware Installation Manual

Power Cycling the Router

After the wires are inserted in the terminal block, use the screwdriver to tighten the terminal block wire
Step 4
screws to keep the wires in place. The screws are shown in
Taking care not to place strain on the wires, insert the terminal block into the mating connector on the
Step 5
router. The mating connector is shown in
Use the screwdriver to tighten the two captive screws on the terminal block to the mating connector. The
Step 6
terminal screws are shown in
Enable DC power by plugging in the DC power supply cord to the power source, or by enabling power
Step 7
at the designated circuit.
Power Cycling the Router
There are two reset buttons on the router cable panel, which can be used to power cycle the router and
to reset the router system software to the default configuration. Use the reset buttons as described in this
section.
Caution When you use the CONFIG Reset button to restore the router to the factory default software
configuration, the current software configuration is permanently deleted from the router.

Accessing the Buttons

You must provide a pin, paper clip, or other thin metal tool to access and press these buttons.
Cisco 1120 Connected Grid Router Hardware Installation Guide
5-10
Figure 5-4.
Figure 5-2. Torque the terminal block screws to 11 lbf-in.
Chapter 5 Connecting the Router to Power
Figure 5-2.
OL-26438-02