Table of Contents
Advertisement
Where to Find Additional Module Information
Item
1
2
Remove Modules
To remove a module from the router:
Step 1
Power down the router as described in the router hardware installation guide on Cisco.com, at:
www.cisco.com/go/cgr1000-docs.
Step 2
Insert the module in the slot as shown in
Using a screwdriver to loosen the module captive screws (two per module) from the connectors on the
Step 3
router front panel.
Step 4
Use your hands to gently pull the module from the router.
Step 5
If needed, power on the router as described in the router hardware installation guide on Cisco.com, at:
www.cisco.com/go/cgr1000-docs.
Where to Find Additional Module Information
For instructions on how to install, replace, and configure the modules, see these installation and
configuration guides on Cisco.com, at:
Table 7-1
Connected Grid Module
Cisco Connected Grid Modules for
CGR 1000 Series – WiMax
Cisco Connected Grid Modules for
CGR 1000 Series – Cellular 3G
Cisco Connected Grid Modules for
CGR 1000 Series – WPAN
Cisco 1120 Connected Grid Router Hardware Installation Guide
7-4
Description
Module captive screws, 2 per module
Router captive screw connectors (4)
Connected Grid Modules for CGR 1000 Series Routers Documentation
Figure
7-1.
www.cisco.com/go/cg-modules
Related Documentation
Cisco Connected Grid WiMAX Module for CGR 1000
Series Installation and Configuration Guide
Cisco Connected Grid Cellular 3G Module for CGR 1000
Series Installation and Configuration Guide
Cisco Connected Grid WPAN Module for CGR1000 Series
Installation and Configuration Guide
Chapter 7
About Connected Grid Modules
OL-26438-02
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Cisco ASR 5000 Application Detection and Control Administration Guide and is the answer not in the manual?
Questions and answers