Restoring Factory Defaults; Capturing A Screenshot Of The Phone Display - Cisco 7925G Deployment Manual

1. Power on the phone while holding down the application button and the speakerphone button simultaneously and keep it
held until Starting Recovery Mode is displayed.
2. A firmware check will then be performed.
3. Insert the USB cable into the phone after USB initialization is complete.
(Ensure that the USB driver has been installed prior and that an IP in the 192.168.1.0 /24 network has been configured
for that network connection)
4. When Web Access Available... is displayed, then navigate to http://192.168.1.100.
5. Browse to the TAR file and then click Upload.

Restoring Factory Defaults

The configuration can be cleared by using the factory default menu option on the phone.
The factory default option erases all user-defined entries in Network Profiles, Phone Settings, and Call History.
To erase the local configuration, follow these steps:
1. Choose Settings > Phone Settings.
2. Press **2 on the keypad.
The phone briefly displays Restore to Default?
3. Press the Yes softkey to confirm or No to cancel.
The phone resets after selecting Yes.

Capturing a Screenshot of the Phone Display

The current display can be captured by browsing to http://x.x.x.x/CGI/Screenshot, where x.x.x.x is the IP address of the Cisco
Unified Wireless IP Phone 7925G, 7925G-EX, and 7926G. At the prompt enter the username and password for the account for
which the phone is associated to.
Cisco Unified Wireless IP Phone 7925G, 7925G-EX, and 7926G Deployment Guide
144