Cisco 7925G Deployment Manual page 56

Advertise G.722 Codec
Home Screen
FIPS Mode
Auto Line Select
Bluetooth
File System Verification
Minimum Ring Volume
7926G Specific Configuration Options
Field Name
Bar Code Symbology Group
Scanner Commands
Below shows the main phone screen (left) and line view (right) display options for the home screen.
Cisco Unified Wireless IP Phone 7925G, 7925G-EX, and 7926G Deployment Guide
G.722 capabilities can be configured on a phone by phone basis and optionally
override the system default.
By default the Cisco Unified Wireless IP Phone 7925G, 7925G-EX, and 7926G
will show the traditional screen with the four icons for directory, services, settings
and line access.
The Federal Information Process Standards (FIPS) mode can optionally be enabled.
When enabled, indicates that the phone will shift the call focus to incoming calls on
all lines. When disabled, the phone will only shift the focus to incoming calls on
the currently used line.
Indicates whether the Bluetooth device on the phone is enabled or disabled.
This parameter indicates whether the phone will perform a file system integrity
check as part of the firmware upgrade process. Enable this option to troubleshoot
file system issues. This feature may impact phone performance if it is enabled.
This parameter controls the minimum ring volume on the phone. This value is set
by the administrator, and can not be changed by an end user. The end user can
increase the ring volume, but may not decrease the ring volume below the level
defined. The minimum ring volume range is from 0 to 7, with 0 (silent) being the
default value.
Description
This parameter specifies the symbology the scanner will use to scan bar codes.
Select Basic or Extended symbology.
Use this field to customize the scanner features. Use comma to separate multiple
commands. Please refer to the Midlet Developer Guide for additional information.
56