Wlan Controller Advanced Eap Settings - Cisco 7925G Deployment Manual

Excessive 802.11-association failures.......... Enabled
Excessive 802.11-authentication failures....... Enabled
Excessive 802.1x-authentication................ Enabled
IP-theft....................................... Enabled
Excessive Web authentication failure........... Enabled
Signature Policy
Signature Processing........................... Enabled
To disable the Auto-Immune feature on the Cisco Unified Wireless LAN Controller, telnet or SSH to the controller and enter
the following command.
(Cisco Controller) >config wps auto-immune disable

WLAN Controller Advanced EAP Settings

Need to ensure that the advanced EAP settings in the Cisco Unified Wireless LAN Controller are configured per the
information below.
To view the EAP configuration on the Cisco Unified Wireless LAN Controller, telnet or SSH to the controller and enter the
following command.
(Cisco Controller) >show advanced eap
EAP-Identity-Request Timeout (seconds)........... 30
EAP-Identity-Request Max Retries................. 2
EAP Key-Index for Dynamic WEP.................... 0
EAP Max-Login Ignore Identity Response........... enable
EAP-Request Timeout (seconds)....................
EAP-Request Max Retries.......................... 2
EAPOL-Key Timeout (milliseconds)......................
EAPOL-Key Max Retries............................
If using 802.1x or WPA/WPA2, the EAP-Request Timeout on the Cisco Unified Wireless LAN Controller should be set to at
least 20 seconds.
In later versions of Cisco Unified Wireless LAN Controller software, the default EAP-Request Timeout was changed from 2 to
30 seconds.
The default timeout on the Cisco ACS server is 20 seconds.
To change the EAP-Request Timeout on the Cisco Unified Wireless LAN Controller, telnet or SSH to the controller and enter
the following command.
(Cisco Controller) >config advanced eap request-timeout
Cisco Unified Wireless IP Phone 7925G, 7925G-EX, and 7926G Deployment Guide
30
400
4
30
86