Using The Cisco Unified Wireless Ip Phone 7925G Desktop Charger; Bluetooth Pairing - Cisco 7925G Deployment Manual

Default Font
Increased Font

Using the Cisco Unified Wireless IP Phone 7925G Desktop Charger

The Cisco Unified Wireless IP Phone 7925G Desktop Charger is a single phone charger including a Bluetooth speakerphone
and supports the Cisco Unified Wireless IP Phone 7925G, 7925G-EX, and 7926G running firmware version 1.4(1) or later.
When the Cisco Unified Wireless IP Phone 7925G, 7925G-EX, or 7926G is paired to the Cisco Unified Wireless IP Phone
7925G Desktop Charger, the audio path will automatically switch to the Bluetooth speakerphone once the phone is docked.
And when removed from the desktop charger, the audio path will return to the previously used audio path (e.g. handset or
speakerphone mode).
The audio volume is controlled from the Cisco Unified Wireless IP Phone 7925G, 7925G-EX, and 7926G by pressing the
volume up or volume down button located on the left side of the phone. Mute can also be initiated by pressing the Mute button
on the left side of the phone.
The audio path is controlled from the Cisco Unified Wireless IP Phone 7925G, 7925G-EX, and 7926G by pressing and holding
the button located on the right side of the phone.
There is a battery slot in the rear of the Cisco Unified Wireless IP Phone 7925G Desktop Charger, which can be utilized for
charging a spare battery or even powering the desktop charger.

Bluetooth Pairing

The Cisco Unified Wireless IP Phone 7925G, 7925G-EX, and 7926G can be paired to the Cisco Unified Wireless IP Phone
7925G Desktop Charger by performing the following steps.
Cisco Unified Wireless IP Phone 7925G, 7925G-EX, and 7926G Deployment Guide
122